Flip the device upside down and glue the 4 EasyApp stoppers as close as possible to the back corners of the device.
Use the wet and dry cloth, included in the set, to clean thoroughly the screen.
If your device has a factory film on, please remove it and clean the screen!
Make sure there are no remaining impurities left, including the curved edges.
Put the film on the device. Make sure that the protective layer marked as no. 1 faces down to the screen.
Put the USB cable (i.e. from your charger) into the dedicated cut-out in the film and plug it into the USB port of your device.
Lift up the film and remove the protective layer no. 1.
Do it gently, while holding the film in a vertical position at all times.
Wipe the screen with the dry cloth, with one move, starting from the USB port side.
eeping the film flexed, lower it down slowly, as low as possible, trying to prevent it from gluing to the screen.
Slide the EasyApp applicator from the USP port side, pressing down the film to the entire surface of the screen.
Make a stop before the glue part and align the cut-outs in the film with the camera and sensors of the device.
With a single, firm move, slide the EasyApp applicator to the end, gluing the first part of the film to the screen.
Do not press the applicator to strongly.
Gently disconnect the USB cable.
Position the Applicator at the edge of the glued part and press it down.
Tilt the unglued part of the film towards the applicator up to the point when the protective layer starts to unglue from the screen side.
Keeping the film in a vertical position, slide the applicator with a soft, even movement and glue the film to the screen.
The protective layer should easily unglue by itself.
Smoothen the film with the applicator. Do not remove any air bubbles at this point.
Gently remove the protective layer by pulling the sticker marked as no. 2.
Notice! The function film may be lifted up slightly, especially in the case of new devices.
Make sure not to unglue it. If needed, hold it down with the applicator.
Use the EasyApp applicator to smoothen the film and push out any possible air bubbles towards nearest edges.
After smoothening of the flat part of the screen, glue the film to the curved edge parts.
Starting from the middle of the device, move the applicator down.
Glue the film thoroughly to all edges by pressing it down with the dry cloth.
Remove the EasyApp stoppers.
Clean the back, sides and screen of the device with the dry cloth.
The film will reach its optimal look after 24 hours
but you can immediately enjoy your protected device.
Không có nhận xét nào:
Đăng nhận xét