Hi there
in this tutorial we're going to show you how to mount the ShredRack Air with Skis and Snowboards on your car
Like described on the back of your bag, we will go through the following steps:
- Inflation
- proper folding of the bladder
- rolling and closing the racks
and mounting them with the according straps
Lets get started
First, remove the two racks from the bag and unroll them
We'll start with inflation, (using the handy punching bag pump built into each air bladder)
with your left hand, take the bladder at the end, and hold it loosely just below the lower cord
with your right hand, hold the end of the pump, and extend it so it fills with air.
grasp the end of the pump firmly with your right hand so no air can escape.
use your right hand to force the air into the bladder
Make sure that the channel is always straight in order to ensure the best airflow
The next step is to close the rack to prevent the air from escaping
close the two velcro straps so the air flow channel is pinched closed and no air can get out
double check that the the folded edge is straight and doesn't have any wrinkles
push the loose end of the pump into the rack that it does not disturb the channel
close the outer portion of the rack with the velcro and start rolling down the end
make sure you are also rolling the open end of the bladder while doing this
finally, close the buckles and you're done
the red loops can be used for extra security
repeat this process for the other rack
Now lets mount the gear on your car roof
Make sure your roof is clean in order to prevent damage or scratching the roof of your vehicle
and then place the racks according to your gear
It is important to find the right spots where you roof is reinforced, and also make sure to observe the maximum load of your vehicle
Once the racks are in place, just lay the gear on top of them
No let's start with the strapping
Always use the lashes of the rack to fix everything together
It's also a good idea to loop the webbing straps through your gear
Close the strap with the buckles
It helps to place the first rack above the B-column, so the strap doesn't disturb the driver
Again, make sure to use the lashes of the racks wisely
Now go to the other side of the vehicle and repeat the procedure
If the straps aren't long enough, you can easily extend them by attaching two straps together
If needed, you may also use the trunk of your vehicle to secure the rear rack
This can be especially helpful with 3-door cars
Finally, tighten the straps firmly and store the left over webbing into the neoprene pockets so there is no noise or fluttering while driving
Finally, enjoy your next adventure and share your stories with us!
To deflate, just open the racks, and unroll the bladder
gently push on the rack, and pull the pump end of the bladder in order to get the air channel open - this should help the air escape quickly.
roll everything up and put it back into the bag




For more infomation >> Youtube Video Download Easy Way || Nurul Alam - Duration: 10:08. 
Không có nhận xét nào:
Đăng nhận xét